Inline Monitoring of continous Ultrasonic Welding Processes of Thermoplastic Composites via a custom polyCMUT based Ultrasound Array

Kurzfassung

Ultrasonic welding (UW) of thermoplastic composites (TCs) is an emerging technology in the field of composite joining techniques in the aerospace sector. Through a mechanical oscillator, ultrasound at a frequency of 20kHz is induced into the material via a welding horn, where microscopic friction and damping effects melt the thermoplastic. Under further pressure the weld area cools down, permanently joining both parts together. Like all joining processes in the aerospace industry the resulting joints need to be tested for their quality and structural integrity. The traditional testing method using water-coupled ultrasound includes extra steps. This process could be considerably improved by assessing the quality of the weld directly after or even during the welding process, allowing for immediate rework or discard of the parts in question. Ultrasound is still the best solution for this quality assessment, being inexpensive, well understood, and able to create B-Mode images, allowing a look into the cross-section of the weld. However, there are several major problems: To increase the system complexity as little as possible it is necessary to attach the ultrasound unit next to the welding equipment, and as close to the welding horn and compactor as possible to save space and keep the end- effector manoeuvrable. This brings problems for classic piezoelectric ultrasonic arrays: The low welding frequency and its resonance modes reach into the lower resonance modes of the piezoelectric sensors leading to immense noise, hiding any potential echo from the welding zone. Classic piezoelectric crystals are also very brittle and can suffer damage from sustained exposure to this violent environment. The authors present a novel solution: a custom-made polymer-based capacitive micromachined ultrasonic transducer array (polyCMUT). polyCMUTs are tiny drums with two electrodes. One on the bottom and the other suspended over a cavity sandwiched between two layers of polymers. By applying a DC-bias an electrical field is created and the membrane is set under tension. If then an AC voltage is applied, the strength of the electric field decreases, allowing the membrane to snap back into its original position. If done at the resonance frequency of the membrane, a strong ultrasonic signal is created. To receive this signal the polyCMUT is charged with a DC-bias, allowing it to receive the echo of the transmitted signal by measuring the changing capacitance. Not only is the polymer robust and inexpensive to fabricate, the general architecture of CMUTs also allows a design where the first mode of resonance is the actual mode the CMUT is operating in. By designing for a resonance frequency over 5 MHz all noise from the initial welding process is ignored, leading to a working pulse echo imaging system. The array is then mounted onto a PEEK block attached to the compactor unit of the welding end-effector. This publication is intended to present initial results, the design process of the custom array and the tests leading there.